Compared to normal size plastic part, plastic big part molding has more considering factors. Then how to realize automatically molding? How to have the suitable factory layout of manufacturing?

As we know manufacturing plastic big part needs large injection molding machine, it requires certain dimension of molding factory.

For example, DKM 1080T injection molding machine, the height of factory should be at least 12meters. If you want to realize automatically manufacturing without opening injection machine safety door, thus it needs to raise machine chassis. Check below machine picture. You can see the machine chassis is much higher than normal one. After demoulding, plastic part will automatic fall down, then transported by conveyor belt.

If your factory height is limited, there is a second solution to fully automatically manufacturing big part. Dig a hole into the ground, when install the machine, it will sink into the hole, so that the height can be reduced effectively. Check below machine picture.

If you have any question, or any new project, please feel free to contact with me.

dkm@dakumar.com

skype: sino-mould-08

Tag:  plastic part automatically moldingbig part molding solutionbig plastic part moldingautomatic molding solutionlarge part moulding